Laser Engraving Rubber Stamp Kit 6pcs

Make your own custom rubber stamps at home instead of waiting on a supplier to send you one. Each rubber mat comes with a 3M adhesive backing already applied, so you peel it off, stick it down and get straight into engraving. The rubber cuts cleanly on your laser, giving you sharp edges and solid ink transfer every time you print.

Mirror your artwork before you engrave, so the stamp prints the right way round. Once it's cut, give the stamp a light scrub with a soft toothbrush and some water or mild dish soap to clear off any leftover debris before you ink it up for the first time. Always run proper ventilation or a fume extractor when your laser is cutting rubber.

Features

• 1x rubber engraving mats, 210mm x 297mm x 2.3mm, with 3M adhesive backing for quick mounting
• 3x wooden stamp pieces, a ball top handle plus two mounting blocks (1.6 x 1.6in and 1 x 1in) so you can match the block to your stamp size
• 1x red ink pad and 1x grey ink pad included
• Soft, fine grain rubber for crisp detail and strong ink retention

What's Included

• 3x Wooden stamp pieces (handle and mounting blocks)
• 1x Red ink pad
• 1x Rubber engraving mats, 210mm x 297mm x 2.3mm, with 3M adhesive backing